Police vehicle involved in traffic accident with no injuries, Asheville NC
TrafficA police vehicle was involved in a traffic accident near Aiken Road in Asheville. Initial reports mistakenly involved a pedestrian, but it was clarified that no pedestrians were involved and no injuries occurred. Emergency units were cleared to resume service.
Audio|Source: Buncombe County Fire
01:33
Transcript:
00:00
MV8[2] following a pedestrian.
00:01
Bacon Road.
00:03
Unknown. Near Aiken Rd.
00:05
Station 20, MV8[2].
00:07
Unknown, near Aiken Rd.
00:09
Curstead of Pleasant Hill Drive.
00:10
I was under Chapel Drive.
00:13
Bunkfire Meds 1641.
00:14
Rescue 20, this is going to be a PD-only[1] accident.
00:18
They're advising you can go in service.
00:21
Copy in time.
00:22
Wrong code was put in, was not pedestrian.
00:24
Agent 20, you can go in service.
00:26
1510. One at least.
00:27
1510, 1642.
00:28
This one an hour.
00:30
This one an hour.
00:31
Agent 20, you can go back in service.
00:33
This was not involved in the pedestrian as has been presented.
00:36
Fire not made it.
00:37
Copy on service, thank you.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
PD-only: Police Department Only (no EMS/Fire needed)
[2]
MV8: Motor Vehicle Accident (initially reported as involving a pedestrian)
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Near Aiken Rd, Asheville, NC 28804
Correct
Incorrect
