No fire found after commercial fire alarm in Monroe, Monroe NC
Fire & ArsonFire units responded to a commercial fire alarm at Brookdale near Fitzgerald Street in Monroe. The alarm was triggered by a smoke detector sensor issue. No smoke or fire was found and no evacuation was needed. Units investigated and remained on standby.
Audio|Source: Union County and North Carolina State Fire
01:7
Transcript:
00:00
See, I'm in June 1, Clint 2, you're en route for a commercial fire alarm, Brookdale,
00:04
near Fitzgerald Street, Cross Street, Ellen Street.
00:09
It's going to be a smoke detector coming from Zone 6.
00:14
It is advised there is sensor trouble.
00:16
You have a hydrant right in front of the building.
00:24
Point two is on the same Fitzgerald Street with nothing visible.
00:28
No evacuation in progress.
00:29
Point two will investigate and hold current assignment.
00:31
Quintu's command.
00:34
10-4[1], Quentin Cone-2 on seeing nothing visible, hold current assignment out-dispatch.
00:42
TMS, you can pull in a gas station parking lot at the intersection.
00:48
Copy. Copy.
00:54
Gas station park on at the intersection.
01:04
Copy. You can pull in the gas station parking lot at the intersection.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
10-4: Acknowledgment / OK
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Near Fitzgerald St, Monroe, NC 28112
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
