Fire alarm activated during construction work in Norman, Norman OK


A fire alarm was reported near South Santa Fe Ave in Norman. Responders were dispatched. The alarm activation was likely due to construction workers resetting the alarm system, not an actual fire.
Audio|Source: Cleveland County Public Safety
01:10
Transcript:
00:00
near South Santa Fe Ave.
00:03
Norman Engine 1, fire alarm[1] at near South Santa Fe Ave, your map page 2.2.
00:08
I'll be on 8 off that disposed in June.
00:12
Clear. (number withheld).
00:13
961 was clear.
00:16
That department's going off again.
00:18
You said earlier that was construction workers, is it in test now?
00:21
Yes, the keyholder was there to start working on the reset and alarm so that's probably what they're doing.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
fire alarm: Fire Alarm
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Near S Santa Fe Ave, Norman, OK 73069
Correct
Incorrect