Fire alarm triggered by debris with no fire found, Scarborough ME


A fire alarm was activated by construction debris in Scarborough. No fire was found, but the fire alarm system had a malfunction. The fire department responded and cleared the scene after reporting the issue.
Audio|Source: Scarborough Fire
00:27
Transcript:
00:00
The detector set off by construction debris, no fire issue.
00:04
Did after issue an SSR[1], unable to get a full reset on the panel.
00:09
There is a trouble in the system.
00:10
Show you're in service.
00:12
Ten for command.
00:13
Detector was set off by construction debris, there's no fire issue.
00:16
You'll be issuing an SSR[1], and all units are clear.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
SSR: System Status Report or Service Status Report
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Scarborough, ME
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect