Fire alarms triggered during system update in residence, Summit County UT
Fire & ArsonMultiple fire alarms were triggered at a residence near Airy Drive and Glenwild Drive due to a system update and replacement. There was no confirmed fire or emergency. Maintenance and the alarm company were contacted, and the situation was confirmed to be a test.
Audio|Source: Summit County Sheriff, EMS and Park City Police
02:29
Transcript:
00:00
So 33 is on two.
00:02
We did go in a few minutes ago, but we actually gave them a call and talked to maintenance.
00:08
Their system is being updated and replaced, and so we're probably going to get more alarms throughout the day, but we were told that it should be in test, and we're going to go ahead and cancel.
00:23
The RP of phone call, the alarm company they'd call back and advise they got in contact with them and they say that they would have someone to meet with you on scene.
00:35
That's affirmative. We spoke with them on the phone. We've got it all squared away on there.
00:44
9-0.
00:45
Security check.
00:50
9-0, security check.
00:58
2887. The alarm on Glen Wild Drive.
01:10
290, security check.
01:16
Have any available units in the area of the Port of Entry?
01:23
431.9.4.2.40.
01:33
It's on a 290.
01:35
Sorry,
01:40
I don't have a very good radio reception here. This driver's been placed out of service for 24 hours. You can show me, clear.
01:50
431, do you copy direct?
01:55
Summitt, you can turn ambulance 41 is en route to Park City Hospital.
02:03
87, you can cancel.
02:09
I'm K-35. Clear no case, not put the trail up to middle school.
02:18
Engine 38 alarm single fanly dwelling near Airy Drive engine 38 on fire 2
Disclaimer:
This transcript was automatically generated and may contain inaccuracies. Please verify the information independently.
Location mentioned:
Glenwild Dr, Utah 84098
This shows a Google Street View of the area near the location, which might not be the exact address.
Correct
Incorrect
