Fire alarm triggered by dust at manufacturing site, Waynesboro PA
Fire & ArsonA fire alarm went off at a manufacturing company on North Franklin Street. Firefighters checked the site and found no fire. The alarm was likely caused by dust from the manufacturing process. No danger was present and the situation was resolved.
Audio|Source: Franklin County Fire Operations
01:10
Transcript:
00:00
Iron County, 24, near North Franklin St.
00:03
Hopewell Manufacturing, showing General Fire Alarm[1], 1257.
00:07
Franklin.
00:08
(name withheld), Lieutenant T's on scene.
00:09
One story, commercial, nothing other than.
00:11
Alpha, Delta. Tentine two on the scene, one story commercial, nothing evident.
00:13
Fours on the scene, off command, all side off at the vehicle.
00:16
T, 24, 12, 57.
00:17
Engine 241 is on scene.
00:19
241, 1258. Franklin.
00:20
Command[2] 24 to Franklin.
00:21
Command[2] 24.
00:22
Dust from the processing set it off.
00:24
That a reset on the system.
00:25
You can place the company two units in service.
00:27
241 will advise when they're ready.
00:29
I'm terminating command. I'm available.
00:30
AT 24 advise des set off the sensor.
00:32
Company 2 in service holding engine 241, 1, 1300.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
General Fire Alarm: Fire alarm activated
[2]
Command: Incident command established
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Near N Franklin St, Waynesboro, PA 17268
Correct
Incorrect
