Fire alarm triggered by gas detection in mechanical room, Wilson WY
Fire & ArsonFire department responded to a gas detection alarm in the mechanical room of a residence. Electricians were working on the property but could not confirm if the alarm was false. No fire or immediate danger was reported.
Audio|Source: Jackson Hole Fire/EMS Dispatch
01:8
Transcript:
00:00
Are you Jackson's invite for page on fire arena? Patient 6, responding for residential fire alarm[1], off 390.
00:07
Engine 6-1 respond for residential fire alarm[1] 6-650 at near Moose Wilson Rd, and to page at (number withheld).
00:14
Jackson, engine six one.
00:16
Ingen, six one.
00:17
Sixth one's in route with two, station six, staff with one ALS.
00:20
This is a gas detection alarm[2] in the mechanical room.
00:26
They did just call back and advise to have electricians working on the house, but they can't confirm that it's a false alarm.
00:32
Also note on this property that it is accessed off an unmarked road going east off the 390 just before Teethan Village.
00:40
Please want to copy.
00:41
Thanks.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
fire alarm: Fire alarm activation
[2]
gas detection alarm: Detection of potential gas hazard
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Near Moose Wilson Rd, Wilson, WY 83014
Correct
Incorrect
